Sega pushes the Mega Drive Mini global release to 2019 | Circuit Breaker Parts

I’d been “dead” 3 times at that point and thought I knew what it meant to be scared, seeing that tanker about to be filled, surrounded by thousands of litres of petrol, diesel, kerosene and other agents of flaming, painful death was and still is the scariest moment of my life. After that nearly being eaten alive by a feral pig or trapped under a hang glider under water was nothing

By using our website and services, you expressly agree to the placement of our performance, functionality and advertising cookies. Learn more Accept

The morals of the story: buy quality components and test them if possible; when in doubt, derate; and make sure a flaming component can’t light anything else on fire. And you’ll want to review the basics of fire protection while you’re at it.

So China are stuck before capitalism’s stable period, the West are now past that. China might end up passing through it, or skipping it altogether. Actually the West might end up learning a few tricks from them.

Once you have the outlet, a level two fast charger is as little as $150 for 16 Amp, which gives 3.5 kilowatts, or $300 for 30 Amps, 7 kilowatts.

First, some background. I am a design engineer working on safety of life critical hardware design and technology development for a military application. I noticed this project a while back, and I invested some thought into how I would design the system.

Australia is similar, except 3ph is uncommon in a house. There’s 3 phase at the kerb and each house is connected to one phase.

Looking at the datasheet for the Fotek SSR-25DA:https://cdn.sparkfun.com/datasheets/Components/General/SSR40DA.pdf

If you hesitate at the thought of doing this math for every system you work on, the NEC Article 110.3(B) states: Listed or labeled equipment shall be installed and used in accordance with any instructions included in the listing or labeling.

Note: Not all certifying agents offer online lookup, and some have a lag time for posting new certificates. If you are unable to find a certificate online, contact the certification agency or supplier for further verification.

I disagree, I think L1 EVSE represent a real safety concern. People use corroded outdoor outlets, poorly wired outlets, extension cords (without proper checking for damage or heat build up), etc.

Which part is wrong? Lets use the IEC definitions of the different systems for clarity and you can educate me with some links to regs where I’m wrong, since I don’t do this for a living or have formal certifications in it. I’ve just a couple of years back installed 380v 3 phase into my barn conversion in mainland France myself and its most definitely a terra terra (TN) earthing system I put in. I had a inspection to get my certificate (certificate du consuel) to connect from a inspector, who during his 3 hr inspection tested the impedance to ground of my independant earth with a megga tester then checked all the earth pins in every socket for spec of impedance back to my earth point, all of which are wired star back to the main consumer unit (ring main is illegal here). We get presented 3 phase wires + a neutral as tails into our main consumer unit from the RCD device (called a disjoncteur) belonging to EDF (supply company) and its not permitted to bond neutral to your own earthing system under the regs.