Google reportedly paid Andy Rubin $90 million after he allegedly coerced sex from employee | 220v Contactor Relay

On the positive side, the mechanism does allow the LCD to be folded facing inwards, providing some degree of protection against minor knocks and smudges when traveling and when you’re content to use the EVF instead. The Xtra Fine LCD panel has a 921,600-dot resolution. The display also uses Sony’s TruBlack technology, which couples a reinforced glass cover plate with anti-reflective film, and a resin filling that removes the air gap beneath the cover plate, which the company says improves contrast and reduces glare under harsh sunlight.

If as the report says. there’s little rear leg room and is being marketed for a 2 person family, then the answer is no.

Very nice. It’s similar to my Toast-R-Reflow power board (though that one has two channels and uses BTA-20s).

As with basically every other high-end Android phone this year, the Mi Mix 3 has a Snapdragon 845 processor, but breaks new memory grounds by including up to 10GB of RAM. Xiaomi is also bundling the phone with a 10W wireless charger. A 5G version is set for release in Europe early next year.

As you said yourself, low current. There is good reason to worry about mains power. The most common breaker is 15A, and that is about 15 times what is needed to kill you. It won’t trip right away either, unless it is so old and weak that it needs replacement anyhow.

https://www.aliexpress.com/wholesale?SearchText=magnetic+lifter 200kg at the flip of a handle. No electricity involved. (The 2000kg version has a bigger handle .

As someone who started playing with electronics in the days of B+ in the 350VDC range with double that across the main xformer’s secondary, I was utterly appalled at the idea of tying myself to a hard ground when working with some of the newer (for the time) solid-state stuff that was coming out. We had a respect for high voltage then that is often missing these days, this article is an excellent reminder that this is still needed.

The place to start when talking about mains-voltage equipment is your bench. We realise you’ll probably be working at your kitchen table or wherever you happen to be, but it’s best to start an article like this with a baseline, of what you really should have when doing this stuff. There are three things we’d consider essential in the mains power system on a mains-voltage bench. An isolation transformer to power the item you are working on if it needs a mains supply, a residual current circuit breaker for the rest of your mains supplies, and an emergency isolation switch for all bench power.

– Use isolated differential probes to measure high voltage. – Use current clamps or current transformers to measure current. – Put bleeding resistors in any big capacitor in your circuit. – Don’t change the position of the probes in the power circuit without power everything down. – Don’t work with high voltages alone. – If there’s more people involved in your experiment, block any circuit breaker, button or at least put some signs to prevent people from turning them on while you are messing with the circuit. Paranoids may even ground things while they are playing with the installation to direct the current to the ground in case someone makes a mistake.

Copyright © 2018 WTWH Media, LLC. All Rights Reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media. Site Map | Privacy Policy | RSS

At the end of the day all power supplies deserve respect, not least because they’re more likely to kill you by burning your house down than through electrocution.

*My* electricity is cheap (~$0.065/kW), so that 117 miles would cost about $7.61. Gas in my area is down to about $2.70/gallon, so the total fuel cost for those 253 miles would be about $16. Other areas of the country might be higher for electricity and lower for gas.